| Remove four passenger seat bolts and remove passenger seat. |
 |
| Lift floor covering and locate the factory Engine Control Unit (ECU). This is a silver box with two multiple wire electrical connectors, plugged in at forward facing end of ECU.
Remove four bolts securing the ECU cover to the floor.
|
 |
| Pull ECU plug latches out to unlock factory ECU plugs. |
 |
| Carefully unplug both factory connectors on the factory loom from the factory ECU, by gently pulling on connector body, NOT wiring. |
 |
| Carefully plug both factory style connectors from the Safari Dtronic Loom Adaptor into the factory ECU.
Carefully plug both factory connectors, into the Safari Dtronic loom adaptor.
|
 |
| Refit Engine Control Unit cover with the four ECU cover bolts.
Remove the adhesive protection-backing sheet from each piece of the supplied Velcro strips and fasten the Velcro to the ECU cover.
Remove the adhesive backing sheet from the each piece of Velcro and fasten one to the Safari Dtronic Computer and the other to the Dtronic Loom Adaptor.
|
| Mount the Safari Dtronic computer and Dtronic Loom Adaptor to the ECU cover.
Plug the small, non-factory connector coming out of the Safari Dtronic Loom Adaptor, into the Safari Dtronic Computer.
|
 |
| Start engine. Ensure engine runs smoothly and without causing the check engine light on the dashboard to illuminate.
Re-fit flooring and passenger seat.
|
