| Open glove box. Depress both sides of the glove box and pull forward and down to open past stops. |
 |
| Remove the three self-tapping screws, which retain the liner and remove same. |
 |
| Locate the factory Engine Control Unit (ECU). This is a silver box with four multiple wire electrical connectors, plugged in at one end.
Unplug all four unique factory connectors on the factory loom from the factory ECU, by depressing the connector lock tab and gently pulling on connector body, NOT wiring.
|
 |
| Plug all four factory style connectors from the Safari Dtronic Loom Adaptor into the factory ECU, in the same order as the factory connectors. |
 |
| Carefully install the Safari Dtronic Loom Adaptor in front of factory ECU as pictured. |
 |
| Plug all four factory connectors, carefully and in the same order as they are in the factory ECU into the Safari Dtronic loom adaptor.
Remove the right hand factory ECU cradle screw and install the Safari Dtronic Auxiliary Module earth strap as shown.
|
|
| Plug the small, non factory connectors coming out of the Safari Dtronic Loom Adaptor, into the Safari Dtronic Computer. |
 |
| Remove the adhesive protection backing sheet from one piece of the supplied Velcro strip and fasten the Velcro to the liner as shown.
Remove the adhesive backing sheet from the other piece of Velcro and fasten to the Safari Dtronic Computer.
|
 |
| Place both Velcro strips together and press firmly, thus mounting the Safari Dtronic Computer. |
 |
| Start the engine and ensure it runs smoothly and without causing the check engine light on the dashboard to illuminate. |
| Re-fit the liner, lower tray and glove box assembly. |
