SS 300HF
Installation Guide
Click Image above for High Resolution Diagram
| LANDROVER DISCOVERY TDI (200 SERIES) TURBO DIESEL (2.5L) | |
| Fitment to: Left hand side
Fitting time: Approximately 75 minutes Comments:
Special Tools:
|
|
| 1 | Remove:
|
| 2 | Tape the template in position on the upper rear corner of the left hand guard. Mark the hole positions with a felt pen. Remove the template. Drill a 4mm pilot hole for each hole. You will need to drill 2 or 3 holes close together to allow the saw blade to penetrate the panel when cutting the main hole. |
| 3 | Drill the 6 mounting holes to 16mm. Tape over the paintwork surrounding the main hole for protection. Cut the main hole using an air hacksaw. (Cut to the outside of the line). Deburr all holes to leave a clean edge. Remove the S/T screw from the guard lip above the main hole. |
| 4 | Screw the stainless steel studs into the front and centre insert positions. Bolt the upper mounting bracket to the snorkel body. |
| 5 | Position the snorkel on the vehicle and secure using the appropriate hardware. The upper mounting bracket is held to the pillar by five 4mm pop rivets. |
| 6 | Remove the air cleaner element from the air cleaner. Cut 20mm off the air cleaner snout. Place rubber edging around the air cleaner body to seal the lid. Refit the element and install the air cleaner to the car. Secure the snorkel snout to the air cleaner with the clamp supplied. Seal the join with silicone. |
| 7 | Fit the air ram to the top of the snorkel and tighten the clamp. Refit the plastic wheelarch liner. Shorten the S/T screw and refit it to the guard lip. |
| WARNING: IT IS THE INSTALLERS RESPONSIBILITY TO ENSURE ALL CONNECTIONS ARE WATER TIGHT. | |
|
ITEM
|
IMAGE
|
DESCRIPTION
|
QTY
|
PART NO.
|
| 1 |
 |
BODY - SNORKEL | 1 | 830-133-000 |
| 2 |
 |
3" AIR RAM ASSEMBLY | 1 | 000-135-050 |
| 3 |
 |
BRACKET - UPPER MOUNTING | 1 | 830-032-000 |
| 4 |
 |
BOLT - 6mm 1.0 x12mm | 3 | 000-002-100 |
| 5 |
 |
BOLT - 8mm 1.25 x16mm | 4 | 000-011 |
| 6 |
 |
WASHER - STAR - 8mm | 4 | 000-305 |
| 7 |
 |
STUD - S/S - 8mm1.25 x 65mm - O/L | 2 | 000-110 |
| 8 |
 |
NUT - NYLOC - 8mm1.25 | 2 | 000-205 |
| 9 |
 |
WASHER - BODY - 8mm x 30mm | 6 | 000-311 |
| 10 |
 |
CLAMP - SIZE 52 | 1 | 000-919 |
| 11 |
 |
POP RIVET - 4mm x 12mm | 5 | 000-958 |
| 12 |
 |
TEMPLATE | 1 | 830-017-000 |
| 13 |
 |
EDGING - RUBBER - 700mm | 1 | 000-953-070 |
| 14 |
 |
HOSE CLAMP - SIZE 48 (BLACK) | 1 | 000-918/B |